- Stock: 2-3 Days
- Model: FFDLB/10
Available Options
Frames 4 Floors are tough
permanent self-adhesive colour coded PVC floor label holders, which will enable
you to place and protect your identification data on the warehouse floor or
wall. The frames are available in five standard ‘lean’ manufacturing colours,
or with black and yellow stripped hazard markings. There are two window sizes,
either A4 size, 210 x 295mm or up to DL size, 210 x 99mm. Supplied in packs of
10
Frames4floors are tough
permanent self-adhesive colour coded floor label holder, which will enable you
to place and protect your identification data on the warehouse floor or wall.
The frames are available in five standard ‘lean’ manufacturing colours, or with
black and yellow stripped hazard markings. There are two window sizes, either
A4 size, 210 x 295mm or up to DL size, 210 x 99mm.
Framing your data could
not be easier, with the frame face down, peel off the centre release panel and
position your document or label, face down onto the adhesive and smooth flat.
Decide on the frame location, then remove the outer release paper, turn the
panel over and press firmly into place on a clean sealed floor. Allow 24 hours
for the adhesive to cure. Once in place this frame will provide a colour coded
window under which data is protected, as well as allowing for quick and easy
barcode scanning. Although designed for use on the floor, this marker can
also be used on walls, doors or anywhere you wish to convey your message.
Supplied in
packs of 10
Available in 2
Insert sizes A4 (210 x 295mm) and DL size (210 x 99mm)
Choice of 6
stand out colours
Permanent
industrial strength adhesive to withstand warehouse traffic
Ideal for
identifying bulk stack locations or highlight important information
Mixed pack of
colours consists of 2 of each Blue, Black, Green, Red and Yellow.